![]() Note: I have created an accompanying video below that illustrates each of the steps on How to Model a Parapet Capping in Revit. Your wall(s) should now be complete with a full Parapet Capping. Once positioned correctly, Press OK and Accept as your rise back up through the menu structure until you are in the Revit Model environment. ![]() Then, use the Distance and Offset values (if required) to position the Parapet Cap Profile correctly in the Preview Section. Make sure it is set to “Top” and not Base. Use the Dropdown under the Profile Column to select your Parapet Cap Profile. Select Add from the bottom of the Wall Sweeps Menu. Select Sweeps from the “Modify Vertical Structure” area. Click “<<Preview” in the bottom left corner, then select “Section” from the View dialogue that appears to the bottom left. Next, select Edit beside the Structure Parameter – this will bring you into the Edit assembly Menu. Then, go to Edit Type in the Type Properties. ![]() Select the wall which you require the Parapet Cap to be hosted to. So, how do you Model a Parapet Capping in Revit? There are many ways to skin a cat in Revit, but the following way is the most straightforward and often most accurate way of modelling a Parapet Cap or Flashing in Revit: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |